ZT-T Tourer rear light fittings

Hi all



The lower fixings that hold the rear lights in place on my ZTT have seized. There is a round captive nut set into the bodywork and a 25mm M4 Philips screw that screws into this fitting. There are two of these on each side plus two small ball joints that allow the unit to swivel away from the body when the screw are undone.



I need to find a replacement captive nut. Does anyone know where I can get/buy a similar item. I have tried the Araldite trick to stop the nut spinning in the bodywork to no avail.



Not sure if I tap two sides of the nut down (its a round thin fitting) to enable it to be gripped then use an electric impact driver to undo the seized screw. Your expert advice would be fabulous as usual.



The replacement plastic sockets for the ball joints seem to much more brittle than the original grey ones. They need softening in boiling water before you plug the ball joint into the socket.

from the last news http://ift.tt/1uZTIiY

via IFTTT