MG TF 135 '02 not starting

Hi folks!

Im new to this forum, and I have searched both this and other forums aswell...



I just bought an '02 TF 135 with a broken cylinder head.

I have now changed the head because all 16 valves on the old was bent, cambelt, waterpump, Alternator belt, and gasket set.

I have set the cam timing for Safe position on the crank, and cams as pointing to the middle. All this has been done with locking tools, so everything is spot on.

My problem is, when I try starting her up, she turns the startermotor, and i can see that it turns the crank aswell. She will not start...

I have pressed the inertia switch, and i can hear the fuel pump active when i turn the key to position 2. My key and remote works fine, and the light for immobilizer goes off. I have tested OBD with my own small tester, and it shows no faults.

I am jumpstarting her, as my battery is flat from when i bought her.



Does anyone have any ideas ? :<



Thx in advance, Nicolai

from the last news http://ift.tt/1rC6Eb8

via IFTTT