CDTi NON starter, look at my measurement !!!
Hello, after changing new injector and HP sensor on pump, ran well but after a short drive stopped and no fire, cranks but not fires at all...guess ive found out the failure...
and here are the numbers of original/mine: HP rail sensor should be 1.35V cranking/mine 1.5.. BUT low pressure pump should read 3.9+- and mine is 1.2V and 0.9little when pump stops.. also the camshaft sensor reads 0.04V which i dont understand..it seems a bit low.. so LP pump would u suggest ?
camshaft sensor.. a bit low.... ?
HP rail sensor when cranking.. id say OK..
this is when pump presses.. a bit low...
and here are the numbers of original/mine: HP rail sensor should be 1.35V cranking/mine 1.5.. BUT low pressure pump should read 3.9+- and mine is 1.2V and 0.9little when pump stops.. also the camshaft sensor reads 0.04V which i dont understand..it seems a bit low.. so LP pump would u suggest ?
camshaft sensor.. a bit low.... ?
HP rail sensor when cranking.. id say OK..
this is when pump presses.. a bit low...
from the last news http://ift.tt/1vMcPMd
via IFTTT
Libellés : IFTTT, the last news
0 commentaires:
Enregistrer un commentaire
Abonnement Publier les commentaires [Atom]
<< Accueil