DIY reprogramming of MEMS3?

A bit of lunch time reading today revealed something I did not know before - it is possible to reprogramme MEMS3 at home!



The MEMS3 ECU uses the Motorola MC 68336 chip set – and with that information, it is possible to discover lots of things regarding re-flashing it using BDM programmers.



In fact, there are products on the market that can do this, including http://ift.tt/1qWmxdn



I'd use Mark at Z&F for any mapping of Project Shed, but I wonder whether the programmer mentioned above could be used for fine tuning as and when other modifications are made?



Any one here got any experience of these?

from the last news http://ift.tt/1qWmxdp

via IFTTT