Fog light bezel and bracket reproduction MGF

Ok so on my mission to get fog lights on my car I have secured the following:



Loom and switch installed



Some knackered plastic brackets with lamps. I am just going to use these as a template and make some from aluminium.



Second hand fog lamp bezels carefully removed from scrapped car.



My thinking is to scan the bezels in to a 3D printer and get a number reproduced to sell at a reasonable price as I know they are like hens teeth. Questions. Does anyone have an idea much say 50 pairs would the cost? Any places I could try in London? Finally would I be in breach of any copyright law in doing so?



With regards the brackets I think their size may prove expensive in reproduction in the same way so I will try to make a set up from sheet aluminium and share the measurements on here if I succeed!



As for the loom there are already solutions posted.

from the last news http://ift.tt/1wkho2a

via IFTTT